Mirror Wardrobe Door Installation
More Videos From Protech Direct
INSTALLATION INSTRUCTIONS
1. Trim Track to Fit Opening*
Using a fine tooth hacksaw, cut the Top Guide Channel and Bottom Track 1/16" (2mm) shorter than the opening width. Insert 2x4(51mmx102mm) wood blocks into channel for support.
*Tracks are delivered slightly oversized and are to be cut down to size on site with a junior hacksaw. This is to ensure a tight and neat finish, and for transportation reasons.
2. Attach Top Guide Channel
Screw Top Guide Channel into the header of your opening locating the front edge 1/16" (2mm) back from the jamb face. Avoid using excessive force when screwing into header as this could deform the Top Guide Channel.
3. Attach Bottom Track
Locate the leading edge of the floor track 7/8" (22mm) back from the front face of the jamb so doors will hang plumb.
4. Install Doors
Tilt the door and insert the top guides into the rear channel. Insert the bottom rollers into the rear groove of the bottom track. To prevent scratching, place two pieces of wood or cardboard over the bottom track. Repeat with the second door, using the front channel and groove.
5. Adjust Doors
For vertical adjustment of each door use a pozi screwdriver on the bottom roller.
